Water Damage And Mold Restoration – What Exactly Is It? It is the process of repairing a house or property to its pre loss condition. Damage to the home could be as a result of an overflow, flood or any other water damage event. The water damage restoration process involves several key procedures like loss assessment, categorization based on the water contamination levels, decontaminating and drying the structure, monitoring of the process and completion of the process. There are 2 large certifying bodies, namely the IICRC (Institute of Inspection, Cleaning and Restoration Certification) and also the RIA (Restoration Industry Association) that recommends standards for water damage restoration. The S500 damage due to water guide is the benchmark tool which is used by companies specializing in restoration of water damage.
Loss Assessment and Categorization – Loss evaluation is the first and the most important step in water damage and mold restoration. The assessment needs to be correct to ensure that an appropriate response can be used. In restorating the injury caused by water, technicians and also the insurance providers must work together and understand what is damaged and how to make restoring the damage. Identifying the source of the damage, documentation of damage, and accurate estimates are mandatory to get a proper water damage and mold restoration. Categorization relies on the contamination levels of the water source. The categories are highlighted below
Category 1 – This can be water from clean sources like pipes, sinks and toilets without faeces or urine.
Category 2 – This is water which includes some contaminants like water from the dishwasher, washer or toilet with urine.
Category 3 – This is water which is highly unsanitary and is capable of causing illness or death if ingested. Sewage water, water from toilet with faeces, standing water with microbial growth and floodwater are a few examples.
Decontamination and Drying – Right after the evaluation is finished, the whole process of drying and decontaminating begins at the site. Based on the extent of damage, damage caused as a result of water can be classified into 4 types. Class 1 Damage- When loss is restricted to some small area and much less water has been absorbed by materials. This leads to slow evaporation rate. Class 2 Damage – When the damage is always to the complete room and carpet area. Class 3 Damage – If the entire area is saturated with water and sophistication 4 Damage – when there are many deep saturation pockets. Decontamination and drying is a key stage in Water damage and mold restoration and equipments like blowers, dehumidifiers, scrubbers and subfloor drying equipments must be used. Decontamination needs to be done if contamination has become detected in the region. Decontamination may be performed for the complete area or in specific pockets where contamination has become detected.
Monitoring and Completion – Monitoring the restoration procedure of damage caused due to damage is crucial to achieve the desired results. One must be proactive during the monitoring process. Checking when the drying devices are setup properly, assessing when the personnel involved are qualified to do the job and checking in the event the equipments are in working order inwtsy all portion of the monitoring process. Necessary steps are to be taken if something wrong is spotted during the monitoring process. The complete procedure for water damage and mold restoration will be classified as complete only once the humidity, temperature and the moisture content is really as per industry standards. Upon finishing of this type of water damage restoration process, the drying equipment can be removed.